Panq

It’s the first nice day for a bit, so I rode the push bike in to work today. Forgot how slippery everything is in the wet and had a brief lie-down in the mud, but still made pretty decent time. I’d call it a fairly decent start to the day.

Tangentially related: we’ve got an electric sit/stand desk that sometimes needs the controller resetting, but the only way to do so is to unplug it and wait for the capacitors to discharge, which takes at least 12 hours or so. I wonder if I can just add a push button and a resistor… 30 seconds is annoying, but would be a huge upgrade from can’t-move-desk-until-tomorrow…

The solar/battery models don’t run 24/7 - you can trigger them remotely (so you can check the live feed whenever) or they can trigger with motion. Still perfectly useful for a bunch of use cases (e.g. just checking if you closed something, or installed somewhere that motion sensing is reliable like a low-traffic corridor) but not super useful for, say, a front door.

Just to second this - I’ve upgraded all but one camera to Reolink RLC-810A a few years back and they’re rock solid. All offline (no internet, but connected to Home Assistant on a separate LAN), all powered by a cheap unmanaged PoE switch from PB Tech. (Edit: this one).

They’re recording 24/7 to their local memory, but I almost entirely use them via Home Assistant’s ability to pull a JPEG directly from the camera (because it takes a fraction of a second at 4k vs the unbearable pain of waiting >10s for video to buffer even at SD resolution).

We had good weather for once, so I went for a reasonably long (43km or so) bike ride and then climbed [a very small mountain] (https://www.doc.govt.nz/parks-and-recreation/places-to-go/auckland/places/mount-william-area/tracks/mount-william-walkway/) that we’ve been meaning to check out for a while.

tips on soldering

In addition to the other comments - if you’re soldering to something that can sink a lot of heat (a great big copper connector, or the ground plane on a circuit board), you will probably need a fairly broad tip. A finer tip can’t transfer heat fast enough, so you end up having to hold it in contact for far too long to get hot enough to melt the solder and (counterintuitively) you end up melting plastic or overheating components. Doubly so if you’ve cranked up the heat to help.

FedEx have their own drivers in Auckland?

I can confirm that they have at least one.

To be fair though, our supplier invests a fairly large chunk of money in freight, and in the past ran their own dedicated flights when the previous carrier (maybe TNT? Can’t remember) wasn’t reliable enough. I have no idea if FedEx is that good in general or if it’s only for these sort of high-priority customers.

Between them, DHL and FedEx get almost all of our parts orders from Melbourne to Pukekohe overnight. They are unbelievably efficient compared to outfits places like Toll or Aramex that can’t get packages across Auckland in under a week.

If I remember correctly, they are allowed to have a thumb throttle if it’s capped at 6km/hr (which is still very handy for starting, especially on a cargo bike). On a generic Bafang/similar motor controller, that’s a purely software limit that anyone with a programming cable can change.

Like some kind of masochist, I volunteered to head in about 90 minutes early, park at Clevedon, and ride to meet them at the top. I was only about five minutes short of actually beating them to the top, which I’m pretty proud of. That climb is hard.

I finally managed to convince my siblings to join me on a bike ride and we went over to Hunua on Sunday and did the easy ride from the top of Moumoukai Hill Road down to the Clevedon market. Highly recommend if you’re in the area, and it was a ridiculously beautiful day for it.

At least federation is doing something with each action. Would be nice if they could be batched, though.

Dumb question: What happens whenever someone spins up a new instance?

I’m in the same boat - zero ads in Sync for Lemmy until this last update. I just assumed the purchase from Sync for Reddit had carried over, but I guess either LJ changed his mind or it wasn’t intentional.

I’m mildly surprised OP’s laptop keeps the bluetooth radio powered up while asleep, but I would be a lot more surprised to find one that doesn’t work with USB HID.

Not my cup of tea, but a few rellies swear by banana and Pic’s crunchy on toast.

That isn’t even a terrible idea - with that many conductors, you should be able to carry tens of amps. Use two for “Data” (detecting charger) and you’ve got… 21 positive and 21 negative. I’d not be surprised to see that hit 100W without catching fire.

I use a dumb 433MHz wireless doorbell (apparently this one on Ali Express, but the exact one doesn’t matter) with a Sonoff RF Bridge running Tasmota. It’s far faster and more reliable than anything with the smarts built into the button, and the battery lasts at least a few years.

I’ve got it set up to take a snapshot on the front door and driveway cameras, send a push notification with the front door camera, announce on the speakers that someone’s at the door, and turn on the outdoor lights at night.

The doorbell was $8 shipped, the RF Bridge was somewhere in the mid $20s but I already had it for some door sensors, and if you don’t already have a camera, a decent Reolink is under $150 shipped directly (or under $250 from a physical shop in NZ like PB Tech).

I’ve had a Chromecast and not apple tv and its quite decent.

The main thing that bugs me about my Chromecast is the gradual loss of functionality over time, presumably as a part of planned obsolescence or deliberately crippling features to make you pay for premium options.

Next time I need to replace/upgrade something, I think I’m just going to skip streaming at all and just hide a full desktop somewhere and pirate everything.

I’m thinking I might go without PoE and just meet my current need, then add a PoE switch to support cameras if or when I get them.

That’s more or less what I did when the dirt cheap AliExpress cameras died - just got a PoE switch from PB Tech and a small pile of Reolink cameras (RLC810A). Definitely the best value-for-money, and works well with Home Assistant. Way better than those stupid splitters or having a pile of individual POE injectors.

Does the insurance cover a rental while waiting on repairs?