This is like 100 years after season 2

Why bother update, Window 12 is going to be out soon anyway.

It took me a hot minute to realise that they were talking about Twitter, lmao.

Just buy the Steam Deck.

Not fast enough

It is ok. The corruption happened because I was trying to revert to a back up on mass (restoring my entire Home directory)

Yeah…

I tried flatpak update -v with no luck. sudo flatpak repair and then reboot does not work either. flatpak uninstall --all it is. Then, I just used Déjà Dup to restore the app configurations, that I had backup.

Also. Thanks for recommending Flatsweep, that is the coolest thing I got out of all of this.

I do most things via flatpakk by default. It provide an aditional layer of reliability to the apps I use. When somehing goes wrong, with a new update or st like that, it would just break the app rather than my entire system. The sandboxing is definitely a plus when using something like WINE, as a lot of games/apps required a specific version of it. Managing them when they are installed natively is really stressful, since mistake there can break you system as well. All of these Flatpak benefits is doublely important when I recommend Linux to less tech-savy people, i.e. my cousin/mom.

Nevertheless, there are apps that have worse-that-native flatpak version, or required to be native to be full-featured (system configuration, i.e. Dconf).

At this state, it is not the trend/potential-growth that we need to keep an eye on. It is the actual current % energy consumption that matter. Nevertheless, your point is very encouraging.

Well. At least I got Lemmy.world out of the fight

But… I am on IOS

Gandalf have no answer to the power of sudo… for better and for worse

Sauce pls

Avoid carpet floors. There are fans venting on the bottom side which you don’t want to clog up with dust

I am 5 years in, and that is still what I do most of the times

Finally, I can bing the whole thing in one go. It was such an effort to avoid any spoiler the past months

Haaaa le lu ya

If you are just starting out. It is best to go with something cheap, but with the important features, which is bed-meshing. It does not really matter who you are buying it from, because unless it is a Prusa, after-sale support will all be spotty or non-existing.

Personally, I got the Ender 3 S1 as my first printer, for $300. The hardware works well and simple enough. But it is the kind of thing you have to tinker with before it can become reliable. Within the first 3 days, I had to switch to Prusa Slicer; because Creality’s slicer does not have the features I need. And, by the end of the week, I had to update the firmware to the open-source “pro” version; because the built-in firmware does not allow me to easily tram the bed or adjust the bed mesh, which cause me hours of troubleshooting and tons of failed print. After that it is all good.

The next big thing right now is not the CoreXY motion system, it is auto-z-calibration (or auto-first-layer), which meant you don’t need to do the weird paper trick every 2-5 prints. The cheapest machine that have that is the Bambu Lab P1P. The next one up (in term of price) is the Prusa MK4. The trade-out between the 2 is that the Prusa have a good track record of support, while Bambu Lab is cheaper and faster.

The number of communities are a lot smaller for sure. But the ones I need are here; i.e. Iinux gaming, popos, anime, hentai.