The new scrum master is working hard

Teaching by example!

Lovely!

I think pictures of said cat would be greatly appreciated 😉

In space, yesterday’s coffee is tomorrow’s coffee

You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing

Pretty straightforward leaves some room for ambiguity. You’re a pion until you decide you aren’t

It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse

Thanks! I’m in Belgium, so location recommandations are welcome, too. The 70x100 frames I found so far are frightfully expensive. It feels ord to spend more on the frame than the art it contains. That said, I would spend the money rather than doing the print the disservice of housing it in a cheap looking frame

Gorgeous! That was an immediate buy. Any tips on where to get a nice frame?

Earmoofs

All constables are guinea pigs

Almost perfect! Of course Akansas should be Nebrahoma. Rookie mistake, but great work otherwise! Gold star

I hate it too. It should be life/work balance. Life comes first. Work to live, not live to work

I am skeptical and don’t expect much. At this point I have all but written off my lifetime membership. In retrospect, it was rather suspicious how quickly went from TestFlight to full release. Communication was almost insulting. Shit happens, but informing as setbacks happen (however brief) garners so much more goodwill than going silent and then posting an apology, especially if you let someone else do it and even more so right after starting to charge for features that were previously free on an app that while looking polished had serious issues with stability and memory leaks

Regardless of the circumstances and events, this way of doing things completely destroys credibility and trust in the future of the product and the developer.

I really want it to succeed and hope the developer really puts in sufficient remedial action to somewhat mend the damage done, but at this point I am not holding much hope for little more than the bare minimum, if anything

Reality surpasses satire https://youtu.be/s_4J4uor3JE?si=fw-xF5aNjKzyXe99

Good bot Link updated

Brave sir Robin ran away https://piped.video/l8IkbCeZ9to

You are doing the thing! That is what matters.

That looks like a failing thermistor or heater cartridge. You might want to swap out both the thermistor and the heater cartridge at the same time. Had something similar happen to me and it turned out the failure of the one, likely influenced the other to wear out prematurely. The cartridge wasn’t exactly broken, but seemed to have a less consistent response curve. You can test them separately, but they are cheap enough that it is not worth the hassle