What you should not do:

Experts have for years pointed out that’s a bad idea – and now Apple is officially warning users not to do it.

“Don’t put your iPhone in a bag of rice. Doing so could allow small particles of rice to damage your iPhone,” the company says in a recent support note spotted by Macworld. Along with the risk of damage, testing has suggested uncooked rice is not particularly effective at drying the device.

What you should do:

If your phone isn’t functioning at all, turn it off right away and don’t press any buttons. The next steps depend on your specific circumstances, but broadly speaking: dry it with a towel and put it in an airtight container packed with silica packets if you have them. Don’t charge it until you’re sure it’s dry.

  • creed10@lemmy.world
    link
    fedilink
    English
    arrow-up
    19
    arrow-down
    1
    ·
    9 months ago

    I was almost convinced the answer was going to be “buy a new iphone”

  • Donk240978@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    4
    arrow-down
    1
    ·
    9 months ago

    I found if the car is nearby, place the wet phone over the windscreen de-mister vent and then run the aircon through that vent. Doesn’t have to be hot air to dry it as long as the compressor for the aircon is running… Aircon dries out the air before blowing it through the cabin so you will have bone dry air circulating around the phone pulling the moisture out by evaporation. About 10 mins is plenty. Best done idling in the shade. Don’t want to sun damage the phone while trying dry it out…

      • Donk240978@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        3
        arrow-down
        1
        ·
        9 months ago

        No, hair dryer works by taking ambient air and heating it before blowing it out. Besides, definitely don’t want to heat up the phone. The aircon dries the air itself as part of the cooling. When using your windscreen vents you don’t have to set the temperature to hot to clear the windscreen as long as that aircon compressor is running. People just do because when you need to defog your windscreen it’s usually cold as fuck outside…

        To dry the phone, set vent to windscreen, temperature to cold, and make sure the aircon indicator on. Cold, dry air.

        • Buddahriffic@lemmy.world
          link
          fedilink
          English
          arrow-up
          4
          ·
          9 months ago

          The heat does help defrost/defog quicker. Hot air can hold more moisture than cold air plus it needs thermal energy to transition from solid/liquid to gas.

          For a phone, the heat is mostly bad because the phone itself is generating heat that it needs to dissipate, so blasting it with hot air will reduce its cooling efficiency and it will find a new equilibrium at a higher temperature. But if the phone is off, I wouldn’t be surprised if it’s fine in the heat (but I also wouldn’t be surprised if it causes issues with some adhesives, so maybe don’t blast it on max unless you can comfortably keep your hand close to the vent).

        • Patches@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          1
          ·
          9 months ago

          When using your windscreen vents you don’t have to set the temperature to hot to clear the windscreen as long as that aircon compressor is running. People just do because when you need to defog your windscreen it’s usually cold as fuck outside…

          I don’t think most people know this. I didn’t and wow okay that makes sense. I didn’t realize AC was so dehumidifying. TIL.

  • TurboWafflz@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    9 months ago

    How exactly do small particles of rice damage a cell phone? I can’t think of any realistic way for that to happen

  • Teknikal@lemm.ee
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    1
    ·
    9 months ago

    I’ve kinda figured out from YouTube repair videos Immediately disconnecting the battery then using pure alcohol and cleaning the components is probably the best solution.

    Unfortunately by the stage I could even open my phone and remove the battery it would probably be wrecked anyway by my attempt to do so.

  • tabular@lemmy.world
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    1
    ·
    9 months ago

    Stop putting your wet iPhone in rice, says Apple. Instead buy a new one because we make repairing it artificially expensive by restricting the manufactures from selling parts and we just replace the whole motherboard every time!

    • Evilcoleslaw@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      9 months ago

      Last I heard Apple won’t even do out of warranty repair work if the device is water damaged. They just tell you to buy a new one.

  • uphillbothways@kbin.social
    link
    fedilink
    arrow-up
    1
    ·
    9 months ago

    Everyone knows the appropriate solution is drying the device in your microwave.
    -brought to you by terrible advice duck or whatever

  • cholesterol@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    9 months ago

    Given that iPhones have had at least IP67 rating since 2016, you probably just want to dry it off and move on.

  • LanternEverywhere@kbin.social
    link
    fedilink
    arrow-up
    1
    ·
    9 months ago

    But silica packets stop doing anything once they’ve absorbed moisture, and so aren’t reusable once they’ve been exposed to normal air moisture. (Unless you’ve baked them to reactivate them). Is that not right? Because basically no one has a box full of re-baked silica packets hanging around ready for emergency usage.

    • AtmaJnana@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      9 months ago

      Hey it’s me. I’m the guy with a bunch of bags of re-baked silica packets. I’m sure I’m in a minority, though.

    • HorreC@kbin.social
      link
      fedilink
      arrow-up
      0
      arrow-down
      1
      ·
      9 months ago

      I have like a gallon bucket of the stuff right now, Mind you its for drying out filament (3d printer), but if you are near and got a wet phone, look me up.

    • lud@lemm.ee
      link
      fedilink
      English
      arrow-up
      1
      ·
      9 months ago

      Here, restaurants sometimes (honestly pretty rare) put rice in the salt dispensers to keep the salt dry, so I doubt salt is great at that.

      • dustyData@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        9 months ago

        Salt absorbs water, and then it does something called caking. Which means it glues into large clumps of crystal when wet then dried, instead of reverting to tiny cubes. The idea of the rice has nothing to do with moisture but to prevent the clumps after the salt dries with a physical barrier. If you shake it in place after it dries, the rice also mechanically break the lumps. It’s an old restaurant trick because they use commercial table salt, which is specifically made for and restaurants has no anticaking agents (usually some form of silicate) and no iodine, so it’s taste is not metallic. That’s how all salt used to be. But modern household table salt does include it, and as result doesn’t cake and it remains granular no matter the moist.

  • Lmaydev@programming.dev
    link
    fedilink
    English
    arrow-up
    0
    ·
    edit-2
    9 months ago

    I used to buy these microwavable things (like a tiny cushion, has a patch on it that changes colour and you microwave to reset it) to dehumidify a certain window in my house. Wonder if they would work.

    • GiveMemes@jlai.lu
      link
      fedilink
      English
      arrow-up
      2
      ·
      9 months ago

      They do! Fun fact you can also microwave regular desiccant packets to reuse them repeatedly.