I’ve done that too. I have small Hakko flush cutters (too delicate) that I use for electronics and cable flush cutters (general purpose). I used the larger cutters but worried that I would damage the scales with them. It’s probably just an experience thing. I’ve done very little of this.
Yessir. I just unpinned and cleaned up someone’s razor a couple weeks using this method. If your tool is free of damage and smooth, it shouldn’t really be an issue. I might also add that I crimp a side then rotate and make the actual cut to help minimize the force needed.
I’ve always just used flush cutters and a punch to get pins free. So far it hasn’t caused an issue for me.
I’ve done that too. I have small Hakko flush cutters (too delicate) that I use for electronics and cable flush cutters (general purpose). I used the larger cutters but worried that I would damage the scales with them. It’s probably just an experience thing. I’ve done very little of this.
Was that on scales that you wanted to save? I’m not sure I’d manage to unoi remove a pin with a flush cutter without some damage to the scales
Yessir. I just unpinned and cleaned up someone’s razor a couple weeks using this method. If your tool is free of damage and smooth, it shouldn’t really be an issue. I might also add that I crimp a side then rotate and make the actual cut to help minimize the force needed.
Interesting! I have a Heljestrand I’m planning to unpin for a good clean up, keeping the scales. I’ll give this a try.