Hi folks,

I’ve been watching too many video reviews and just want a little bit of advice before I make my purchase. I’m wanting to get into 3d printing with the most satisfying results possible for around $600 CAD .

I’m looking at the Ender 5 S1 , currently for $599 CAD on Amazon. It does what I want , I think, it gets nice and hot (300C) , can use lots of different materials, auto levels, uses.usb and wifi, is quick and has a cube frame.

I suspect I would be quite happy with it. But before I go and pull the trigger, is there anything else around this price range , say plus or minus $100 , that would be better? If so what advice can you give? What models should I investigate.

  • Hang@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    I have a handful of printers including an Ender 3v2 and a Creality CR10S4, and my experience with Creality printers is that while they are cheap & usually offer nice features they are lacking in quality control & overall quality of the parts used (though the sprite extruder is a beast). If you are willing to put the time into tinkering with them then you can still make out with a decent printer for less than most comparable manufacturers.

    Based on the features you listed I think the Qidi X-Smart 3 might be down your alley. The first few months after release were a shitshow with the firmware but now it’s in a really solid place & mine has been quite reliable. It has a smaller build volume than the Ender 5 S1 but can print significantly faster.

    If you are willing to expand your budget a bit I’ve noticed that Bambu Labs has dropped the price of the P1P to $600usd/~$800cad. I don’t have any personal experience with Bambu Labs printers & honestly dislike some of the companies practices, but everything I’ve heard about the P1P & X1C has been fantastic.

    • TooL@lemmy.ca
      link
      fedilink
      arrow-up
      5
      ·
      1 year ago

      As a new owner of a p1p. It’s the single best decision I’ve made as far as the 3d printing hobby goes. I cannot tell you how much time and money I sunk into my old bed slinger printer and the results never even got close to this thing out of the box.

      The only downside? You’re gonna absolutely tear through filament because of how well and fast it prints.

    • Funderpants @lemmy.caOP
      link
      fedilink
      arrow-up
      2
      ·
      edit-2
      1 year ago

      Truth is I am not able to tinker as much as I would like, 2 kids and a busy job gets in the way. I’d rather tinker with software and design than hardware these days. I am willing to expand the budget a bit to ensure.that experience. This is twice now the P1P has come up. I’ll check that and the X-smart out.